IISc Logo    Title

etd AT Indian Institute of Science >
Division of Electrical Sciences >
Electrical Communication Engineering (ece) >

Please use this identifier to cite or link to this item: http://hdl.handle.net/2005/356

Title: Low Power LO Generation Based On Frequency Multiplication Technique
Authors: Pandey, Jagadish Narayan
Advisors: Amrutur, Bharadwaj
Keywords: Frequency Multiplexing
Local Oscillator (LO)
Signal Processing
Quadrature Generation
Local Oscillator (LO) Pulling
Local Oscillator Signals
Frequency Multiplication
Frequency Multiplier
Submitted Date: Jul-2007
Abstract: TO achieve high level of integration in order to reduce cost, heterodyne architecture has made way for low-IF and zero-IF (direct conversion) receiver architectures. However, a very serious issue in implementing both zero and low-IF receiver is of local oscillator (LO) pulling. Another challenge is on-chip generation of high-precision quadrature LO signals for image-rejection. We have addressed both these issues in this thesis. Regarding the first problem, we have developed a lowpower frequency multiplication technique which uses a low frequency ring oscillator and multiplies its frequency in power e cient way to generate the desired frequency. We then use this differential LO signal to generate high-precision quadrature phases by using polyphase filter and an injection-locked quadrature oscillator. Design examples are presented for 2.4 GHz band of IEEE 802.15.4 standard which is a low-data rate WPAN standard. The standard o ers relaxed performance specifications in order to help achieve low power of operation. Contributions in the thesis • The problem of local oscillator (LO) pulling can be addressed by running LO at a much reduced frequency and use a frequency multiplier (FM) to generate the desired frequency. Also, use of low-frequency LO saves power in VCO and helps eliminate first few dividers leading to significant power savings. In addition, the entire frequency synthesizer can be run at a lower supply voltage saving additional power. The frequency multiplier involves combining edges from the lower frequency ring oscillator. It improves upon the prior work by proposing a new lower-power edge-combiner. The overall power is reduced by exploiting the relaxed phase noise specification of IEEE 802.15.4 standard. Simulations using SpectreRF show that the circuit consumes only 550 オW of power in 0.13 オm RF-CMOS technology with 1.2 V supply voltage, and provides 950 VP-P sinusoidal output with phase noise of -85.5 dBc/Hz at 1 MHz offset. • An injection-locking based quadrature desensitization circuit is designed for precision quadrature generation. The differential (two phase) output of the frequency multiplier is fed to a polyphase filter to generate nearly quadrature signals. Output of polyphase filter is in turn fed to the desensitizer circuit to obtain high-precision quadrature signals. Designed for 2.4 GHz band in 0.13 µm RF-CMOS technology, it achieves a phase error of 0.5 for 1% mismatch in LC tanks. It achieves a phase noise of -84.3 dBc/Hz at 1 MHz o set and provides quadrature sinusoids of 475 mV amplitude while consuming 1.56 mW of power. • We have analyzed the popular cross-coupled LC-VCOs to generate quadrature sinusoids. In practical LC-oscillators built using low/moderate quality factor on-chip inductors, the actual frequency of oscillation is a little less than 1/2pvLC . This is known as Groszkowski effect. On the other hand, in quadrature oscillator topologies, consisting of two, cross-coupled, negative resistance LC-VCOs using parallel coupling transistors, an upward shift in frequency of oscillation from the free-running frequency of each LC-VCO is observed. This is because in order to satisfy the Barkhausen’s criteria, the LC-tanks have to operate at a frequency away from the frequency of resonance. This e ect called as quadrature detuning effect results in higher phase noise and reduced amplitude. We have shown that the old treatment given in literature is quite inaccurate for practical LC oscillators that are built using low/mo derate Q on-chip inductors. Also the prior work ignores Groszkowski effect which could be significant for low Q LC tanks. We have provided simple, accurate and closed-form expressions of associated frequency-shifts and amplitude of oscillation including both the effects. Our results show excellent match with results obtained from SpectreRF and Matlab simulations.
URI: http://hdl.handle.net/2005/356
Appears in Collections:Electrical Communication Engineering (ece)

Files in This Item:

File Description SizeFormat
G21048.pdf2.28 MBAdobe PDFView/Open

Items in etd@IISc are protected by copyright, with all rights reserved, unless otherwise indicated.

 

etd@IISc is a joint service of SERC & IISc Library ||
Feedback
|| Powered by DSpace || Compliant to OAI-PMH V 2.0 and ETD-MS V 1.01