IISc Logo    Title

etd AT Indian Institute of Science >
Division of Physical and Mathematical Sciences  >
Physics (physics) >

Please use this identifier to cite or link to this item: http://hdl.handle.net/2005/569

Title: High Precision Optical Frequency Metrology
Authors: Das, Dipankar
Advisors: Natarajan, Vasant
Keywords: Metrology
Optical Measurements
Precision Spectroscopy
Alkali Atoms - Spectroscopy
Ring Cavity Resonator
Lithium - Spectroscopy
Hyperfine Spectroscopy
Yb
173Yb Isotope
Hyperfine Structure
Optical Frequency Metrology
Absolute Frequency Measurements
High-Precision Measurement
Precise Measurement
Precise Measurements
Laser Cooling
Submitted Date: May-2007
Series/Report no.: G21487
Abstract: Precise measurements of both absolute frequencies and small frequency differences of atomic energy levels have played an important role in the development of physics. For example, high precision measurements of absolute frequencies of the 2S½ → 2P ½ transition (D1 line) of alkali atoms form an important link in the measurement of the fine structure constant, α. Similarly, precise interferometric measurements of the local gravitational acceleration (g) rely on the knowledge of the absolute frequencies of the 2S½ → 2P 3/2 transition (D2line) in alkali atoms. Difference frequency measurements of hyperfine structure and isotope shifts of atomic energy levels provide valuable information about the structure of the nucleus, which in turn helps in fine tuning the atomic wave functions used in theoretical calculations. The work reported in this thesis starts with the development and refinement of high precision measurement of absolute frequencies using a ring-cavity resonator. The measurement technique is relatively simple and cost-effective, but the accuracy is comparable to that achieved with the frequency comb technique (10¯11) when the accuracy is limited by the natural linewidth of the transition being measured. The technique combines the advantages of using tunable diode lasers to access atomic transitions with the fact that the absolute frequency of the D2 line in87Rb is known with an accuracy of 6 kHz. A frequency-stabilized diode laser locked to this line is used as a frequency reference, along with a ring-cavity resonator whose length is locked to the reference laser. For a given cavity length, an unknown laser locked to an atomic transition has a small frequency offset from the nearest cavity resonance. We use an acousto-optic modulator (AOM) to compensate for this frequency offset. The measured offset is combined with the cavity mode number to obtain a precise value for the frequency of The unknown laser. We have used this technique for absolute frequency measurements Of the D lines in133Cs and 6,7Li, and the 398.8nm line in Yb. We have also developed a technique to measure the ‘difference frequency’ of atomic energy levels using a single diode laser and an AOM. In this technique, the laser is first locked to a given hyperfine transition. The laser frequency is then shifted using the AOM to another hyperfine transition and the AOM frequency is locked to this difference. Thus the AOM frequency directly gives a measurement of the hyperfine interval. Applying this AOM technique we have measured the hyperfine interval of the D1 lines of all alkali atoms with high precision. We have further developed a technique of coheren-tcontrol spectroscopy (CCS) using co-propagating control and probe beam that is useful for highresolution spectroscopy. In this technique, the probe beam is locked to a transition and its absorption signal is monitored while the control beam is scanned through neighbouring transition. As the control comes into resonance with another transition, the probe absorption is reduced and the signal shows a Doppler free dip. This technique allows us to resolve transitions that are otherwise swamped by crossover resonances in conventional saturated absorption spectroscopy (SAS). We have applied this technique to measure hyperfine intervals in the D2 line of several alkali atoms. Thus, we were able to do high-precision measurements of both absolute and difference frequency of atomic transitions. The precision of the absolute frequency measurement is finally limited by the accuracy of 6 kHz with which the reference frequency is known. The nearby two photon transition in Rb, i.e. the 5S1/2→5D3/2 transition at 778 nm, is known with an accuracy of 1 kHz. In future, we hope to improve the accuracy of our technique using this transition as the reference. This thesis is organized as follows: In Chapter1,we give a brief introduction to our work.. We review the importance of frequency measurements and precision spectroscopy, followed by a comparison of the frequency comb and our ring cavity technique. In Chapter2, we describe measurements of the absolute frequency of the D lines of 133Cs using the ring cavity. We give a detailed discussion of the technique, the Possible sources of errors, and ways to check for the errors. The measurement of the absolute frequency of the D lines of Cs allows a direct comparison to frequency comb measurements, and thus acts as a good check on our technique. In Chapter 3, we describe the absolute frequency and isotope shift measurements in the 398.8 nm line in Yb. We probed this line by frequency doubling the output of a tunable Ti:Sapphire laser. We obtained< 60 kHz precision in our measurements and were able to resolve several discrepancies in previous measurements on this line. In Chapter 4, we describe the measurement of hyperfine structure in the D1 lines of alkali atoms. We used conventional saturated-absorption spectroscopy in a vapor cell to probe different hyperfine transitions and then used our AOM technique to measure the hyperfine interval with high precision. In Chapter 5 we discuss our measurements of hyperfine structure in the D2 lines of several alkali atoms. In the case of 23Na and 39K, the closely-spaced hyperfine transitions are not completely resolved in conventional saturatedabsorption spectroscopy due to the presence of cross over resonances. We have used coherent control spectroscopy to obtain crossover-free spectra and then measured the hyperfine intervals using an AOM. This technique was also used for high resolution spectroscopy in the D2 line of 133Cs. Finally, we describe our measurements of hyperfine structure in the D2 line of Rb using normal saturated absorption spectroscopy. Chapter 6, describes the relative and absolute frequency measurements in the D lines of6,7 Li at 670nm. High-precision measurements in lithium are of special interest because theoretical calculations of atomic properties in this simple three electron system are fairly advanced. Lithium spectroscopy poses an experimental challenge and we describe our efforts in doing highresolution spectroscopy on this system. Chapter 7 describes the hyperfine spectroscopy on the1P 1 state of 173Yb. Measurement of hyperfine structure in 173Yb has a problem because two of the hyperfine transitions overlap with the transition in 172Yb. In our earlier work (described in chapter 4), we had solved this problem by using multipeak fitting to the partially resolved spectrum. Here, we directly resolve the hyperfine transitions by using transverse laser cooling to selectively deflect the 173Yb isotope. In Chapter 8 , we give a broad conclusion to the work reported in this thesis and suggest future avenues of research to continue the work commenced here.
URI: http://hdl.handle.net/2005/569
Appears in Collections:Physics (physics)

Files in This Item:

File Description SizeFormat
G21487.pdf2.75 MBAdobe PDFView/Open

Items in etd@IISc are protected by copyright, with all rights reserved, unless otherwise indicated.

 

etd@IISc is a joint service of SERC & IISc Library ||
Feedback
|| Powered by DSpace || Compliant to OAI-PMH V 2.0 and ETD-MS V 1.01
Please not that the site address will change from etd.ncsi.iisc.ernet.in to etd.iisc.ernet.in